How often to clean solar panels, whether it pays, and how to do it safely, 2026
Most Thai homes do not need to clean their panels every six months. One installer recommends every two to three years for a typical home, adjusted for dust, location and the maker's manual [1]. Cleaning costs about 2,500 to 4,000 THB a visit [1], while a 5 kW system losing 5% of its output to dirt gives up about 1,600 THB of savings a year (our calculation). Cleaning pays when the app shows a clear drop in output, not by the calendar.
Key facts
- Cleaning costs about 2,500 to 4,000 THB a visit and a detailed system check about 1,500 to 3,000 THB, according to an installer's estimates [1].
- Some packages already include cleaning: Synnex's packages at JIB include two cleanings, and HomePro's 8 kW all-in-one set includes cleaning and a check once a year during the installation warranty [2][3].
- LONGi requires cleaning water within 10°C of the panel temperature and water pressure on the panel surface of no more than 0.7 MPa [4].
- Clean in the early morning, at dusk or on a rainy day, when irradiance is no more than 200 W/m², and never step on the panels [4].
- Do not use abrasive powders, acid or alkaline cleaners, or metal tools, which scratch the glass [4].
- A system not maintained according to the maker's manual may lose its warranty [5].
kWp is the peak capacity of the solar panels; kW is the size of the inverter or the system.
When does cleaning pay?
Cleaning pays when the savings recovered exceed its cost. This table uses a 5 kW system producing about 560 kWh a month [6], with self-used power worth about 4.84 THB per kWh [7].
| Output lost to dirt | Power lost a month (kWh) | Savings lost a year (THB) | Is one cleaning at 2,500 to 4,000 THB worth it? |
|---|---|---|---|
| 3% | About 17 | About 980 | No |
| 5% | About 28 | About 1,600 | No |
| 10% | About 56 | About 3,250 | Yes, if output stays restored for most of a year |
| 15% | About 84 | About 4,900 | Yes |
Our calculation, assuming the loss would last all year without cleaning. Rain washes off some dust in the wet season, so compare output with the same month last year, not with your sunniest month. A system selling its surplus at 2.20 THB loses less than the table shows.
Signs that it is time to clean
- A clear drop in output in the app Compare with the same month last year, or with a similarly sunny day after the last cleaning.
- Bird droppings or leaves Dirt that shades part of a cell cuts output more than a thin film of dust over the whole panel.
- Low-tilt panels Panels laid nearly flat shed less dust in the rain than tilted ones.
- Nearby dust sources Such as roads with truck traffic, construction, factories or open burning.
- A cleaning included in your package If your package includes cleaning, use it before paying for more.
How to clean safely yourself
| Do | Do not |
|---|---|
| Clean in the early morning or evening, when the panels are not hot [4] | Spray cold water on panels baking at noon, a difference of more than 10°C [4] |
| Use tap water, soft sponges, non-woven cloth or soft nylon brushes [4] | Use abrasive powder, wire brushes, blades, or acid or alkaline cleaners [4] |
| Use low water pressure, no more than 0.7 MPa on the panel surface [4] | Use pressure washers or steam [4] |
| Clean from the ground with an extension pole, or hire a crew with fall protection | Climb onto or step on the panels [4] |
| Wear gloves so you leave no fingerprints on the glass [4] | Touch damaged cables or connectors while the panels are producing |
Steep roofs and roofs above the first floor are best left to a crew with safety equipment. Panels produce power whenever there is light, even with the inverter switched off; see more precautions in solar system safety.
Read next: Low solar output, Solar warranties, Which solar panel brand?, installer rankings and how we score.
Frequently asked questions
How often should solar panels be cleaned?
There is no single figure for every home. One installer recommends every two to three years for a typical home, but homes near dust sources, low-tilt panels or panels with bird droppings may need cleaning more often. The best guide is your app: compare output with the same month last year and clean when it has clearly dropped.
How much does panel cleaning cost?
About 2,500 to 4,000 THB a visit, depending on system size, site conditions and distance. A detailed system check, such as the inverter and switchboard, costs about 1,500 to 3,000 THB a visit, according to an installer's estimates cited by Thansettakij. Some packages already include cleaning.
How much output does dust cost?
It depends on location, rain and tilt. A 5 kW system losing 5% of its output gives up about 1,600 THB of savings a year, and at 10% about 3,250 THB, by our calculation. A cleaning at 2,500 to 4,000 THB therefore pays when output has fallen by about 10% or more.
Can I clean panels with tap water?
Yes. LONGi says municipal water can be used, though water high in minerals can leave deposits on the glass and reduce output. Keep water pressure low, no more than 0.7 MPa, and the water within 10°C of the panel temperature. Do not use abrasive powder, acid or alkaline cleaners, or steam.
What time of day is best for cleaning?
Early morning, dusk or a rainy day, when irradiance is no more than 200 W/m², according to LONGi's manual. The panels are cool, which lowers the risk of cracking the glass with much colder water, and there is less risk of people shading the panels while cleaning, which can create hot spots on cells.
Will cleaning panels myself void the warranty?
Not if you follow the maker's manual. Using tools or cleaners the manual forbids, stepping on the panels, or installing and maintaining the system against the manual may void the warranty. Read the manual for your panel model and ask your installer what the contract says about cleaning them yourself.
Sources
- Thansettakij: one million rooftop solar households, cleaning and maintenance costs after installation, figures from Solar Power Creation. https://www.thansettakij.com/economy/670304 Published 30 September 2026, read 17 November 2026.
- JIB: Synnex Solar Roof Huawei Save 5 kW 1-phase with 7 kWh battery, 2-year installation warranty, 2 panel cleanings. https://www.jib.co.th/web/product/readProduct/86308 Read 13 November 2026.
- HomePro: ENERGY LIB P1 ALL IN ONE 8 kW single-phase set, cleaning and system check once a year. https://www.homepro.co.th/p/1279912 Read 17 November 2026.
- LONGi: PV module operation and maintenance manual V2.0, section 2.2 on cleaning. https://static.longi.com/LON_Gi_Maintenance_Manual_V2_0_EN_43815b2263.pdf Read 17 November 2026.
- LONGi: PV module user manual; failure to follow it may void the warranty. https://static.longi.com/LON_Gi_PV_Module_User_Manual_for_DGBG_1_0_260409_114d652c10.pdf Read 17 November 2026.
- Global Solar Atlas (World Bank and Solargis), site data for Bangkok. https://globalsolaratlas.info/map?c=13.7563,100.5018,11&s=13.7563,100.5018&m=site Read 13 November 2026.
- Government Public Relations Department: the new tariff structure from the September 2026 bill. https://www.prd.go.th/th/content/category/detail/id/33/iid/536793 Published 30 August 2026, read 17 November 2026.